Instruments - 8R0 920 931 G

Coding for Instruments 8R0920931G on Q5

8R0 920 931 G :H35 / :0564
Coding: 03  E7  22  00  4F  01  00  08  01  00  00 
label: 8R0-920-xxx-17.clb
Faults: 0
# Byte 0 [03] / Binary: 00000011
bit 0 ☑ 
bit 1 ☑ 
bit 2-4
bit 5 ☐  Right-Hand-Drive (RHD)
bit 6 ☐  Speed Warning at 120 kph (75 mph) active
bit 7 ☐  Brake System Warning Light North American Region (NAR) OR Australia (AUS) active
# Byte 1 [E7] / Binary: 11100111
bit 0 ☑  Gauge Test/Needle Sweep active
bit 1 ☑  Engine Start Note (i.e. "Press Clutch to Start Engine")
bit 2 ☑  Driver Information System (DIS) active
bit 3 ☐  Lap Timer active
bit 4 ☐  Washer Fluid Warning active
bit 5 ☑  Shift Suggestion (Economy) active
bit 6 ☑  Multi Media Interface Generation 3 (MMI 3G) installed
bit 7 ☑  Key Warning active
# Byte 2 [22] / Binary: 00100010
bit 0 ☐ 
bit 1 ☑ 
bit 2 ☐ 
bit 3-7
# Byte 3 [00] / Binary: 00000000
bit 0-2
bit 3 ☐ 
bit 4 ☐ 
bit 5 ☐ 
bit 6 ☐ 
bit 7 ☐  Wheel Speed Error Counter active
# Byte 4 [4F] / Binary: 01001111
bit 0 ☑  Tire Pressure Monitoring (TPMS) installed
bit 1 ☑  Electro Mechanical Parking Brake (EPB) installed
bit 2 ☑  Adaptive Cruise Control (ACC) installed
bit 3 ☑  Adaptive Light (Swivelling Headlights) installed
bit 4 ☐  Dynamic Ride Control (DRC) installed
bit 5 ☐  Dynamic Steering installed
bit 6 ☑ 
bit 7 ☐ 
# Byte 5 [01] / Binary: 00000001
bit 0 ☑  Adaptive Air Suspension installed
bit 1 ☐ 
bit 2 ☐ 
bit 3 ☐ 
bit 4 ☐ 
bit 5 ☐ 
bit 6 ☐ 
bit 7 ☐ 
# Byte 6 [00] / Binary: 00000000
bit 0 ☐ 
bit 1 ☐ 
bit 2 ☐ 
bit 3 ☐ 
bit 4 ☐ 
bit 5-6
bit 7 ☐  Time Display (0 = 24h / 1 = 12h AM/PM)
# Byte 7 [08] / Binary: 00001000
bit 0 ☐ 
bit 1 ☐ 
bit 2-3
bit 4 ☐ 
bit 5 ☐ 
bit 6 ☐ 
bit 7 ☐ 
# Byte 8 [01] / Binary: 00000001
bit 0-4
bit 5 ☐ 
bit 6 ☐ 
bit 7 ☐  Special Characters allowed
# Byte 9 [00] / Binary: 00000000
bit 0-7
# Byte 10 [00] / Binary: 00000000
bit 0 ☐  Brake Pad Wear Warning active
bit 1 ☐ 
bit 2 ☐ 
bit 3 ☐ 
bit 4 ☐ 
bit 5 ☐ 
bit 6 ☐ 
bit 7 ☐  
Address 17: Instruments (J285)       Labels: 8R0-920-xxx-17.clb
   Part No SW: 8R0 920 931 G    HW: 8R0 920 931 G
   Component: KOMBIINSTR.   H35 0564  
   Revision: 00000000    Serial number: ZDM224NAE     
   Coding: 03E722004F010008010000
   Shop #: WSC 06335 123 12345
   VCID: 397EE1AFB05D73F66C-806D
 
1 Fault Found:
01319 - Control Module for Distance Control (J428) 
            004 - No Signal/Communication